A lint-free cloth, water and gentle handling are a practical starting point for everyday care.

Editorial illustration of a clear crystal block and lint-free cloth.
To clean a 3D crystal keepsake, use a clean, lint-free cloth and water, and avoid abrasive materials. 3DCrystal’s care FAQ says water or glass cleaner can be used; a special branded crystal cleaner is not necessary. Starting with water keeps the routine simple.
The aim is to remove dust and fingerprints gently. Check the cloth before using it, support the crystal securely and take your time around edges and corners.
Prepare the crystal and your workspace
Choose a clear, stable surface with enough room to work. Lay down a clean, soft cloth so you have somewhere to place the crystal without sliding it across a hard tabletop.
If the keepsake rests on a separate light base, lift the crystal off before cleaning. Support it with both hands when needed, especially if it is large or awkward to hold. Keep the cleaning cloth and water away from electrical accessories.
Wipe gently and dry the surface
Check that your lint-free cloth is free of grit or debris. Use a clean section as you work so you are not repeatedly rubbing the same dirt across the crystal.
Lightly dampen the cloth with water and gently wipe the outside surfaces. Work on one face at a time, keeping a secure hold rather than balancing the piece on a corner. Finish with a dry, clean lint-free cloth to remove remaining moisture and streaks.
Avoid abrasive pads, gritty cloths and scouring products. If you choose glass cleaner, follow its directions and keep it away from the base and surrounding furnishings. More pressure is not a useful substitute for a clean cloth.
Handle it with the display in mind
After cleaning, return the crystal to a stable position where it is fully supported. Lift it when moving it, rather than dragging it across a shelf. A position away from an easily knocked edge makes everyday handling easier.
If you use one of 3DCrystal’s light bases, treat the accessory as a separate item with its own care instructions. The crystal-cleaning advice is not permission to wet an electrical base.
A few additional care questions
Does cleaning touch the engraved picture?
The photograph is laser engraved inside the crystal. Routine wiping cleans the outside surface; it does not reach the internal artwork.
How often should I clean the crystal?
Use visible dust and fingerprints as your cue. Check the keepsake when you dust the surrounding shelf, and clean it gently when needed rather than following an elaborate polishing schedule.
What if a mark remains after gentle cleaning?
Pause rather than trying abrasive polishing or scraping. Send the team a clear photograph and describe the mark so they can advise on your particular keepsake.
A simple routine is enough to begin: clean cloth, gentle wiping and secure handling. For an unfamiliar mark or a question about your own crystal, ask the team before experimenting with a stronger treatment.









